Alongside the wall shelf, the packaging also contains a number of shelf brackets; how many depends on the size you have ordered.

Download the Blob wall shelf instructions as a PDF here

Download the drill hole template as a PDF here

1. Keep the following tools to hand: hammer, spirit level, drill, Torx screwdriver (T25) and wall plugs (M8) (depending on the type of wall).


2. Check that every part of the Blob wall shelf you ordered is in your package.


3. On the last page of these instructions you will find templates showing the correct drill holes for each shelf size. Cut this out and tape the strips of paper together.


4. Hold the template against the wall and drill the marked holes into the wall. Then carefully pull the template off the wall. Push wall plugs into all the holes; which type of plug you need depends on the type of wall.


5. Now screw part (A) of the shelf bracket into the wall using a Torx screwdriver (T25). Then hand-tighten part (B) of the shelf bracket onto parts (A).


6. Now carefully slide the shelf over the shelf brackets. The brackets can still be adjusted slightly by tightening them a little with a spanner, so that the shelf grips well and hangs straight.